Paintball Guns and Gear forums banner

1 - 7 of 7 Posts

·
Registered
Joined
·
8 Posts
Discussion Starter #1
I recently installed a expansion chamber and got it all installed and must have put something back together wrong? The gun will shoot after I cock it but doesnt relad to be shot again, I have to pull the pin on the side back every time? Is it the sear spring ( whaterver that is?)
 

·
Screaming Koala
Joined
·
4,685 Posts
It might be the sear spring, it might be a lot of things.

Does it seem starved for air? I mean, the one shot it does take, does the ball have a normal velocity?

First things first though, Cock the gun, fold the feedneck down and look into the chamber. Is your ball detent in backwards? Needs to curve up towards the front of the gun.
 

·
Registered
Joined
·
8 Posts
Discussion Starter #3
no doesnt seem starved for air it does everything normally like the velocity sounds right and it shoots just doesnt re-cock.
 

·
Registered
Joined
·
8 Posts
Discussion Starter #4
Also I was wondering where I could find some kind of hi pressure like to make a custom line off of the expansion chamber to the drop forward because the like the expansion chamber kit comes with is long and looks kinda funny. If I put on the old setup it still wont re-cock either.
 
1 - 7 of 7 Posts
Top