Paintball Guns and Gear forums banner

1 - 20 of 33 Posts

·
Registered
Joined
·
14 Posts
Discussion Starter #1
i have a problem with my pm6. as soon as i put my tank on the air just rushes out of the chamber. i put a full 4500 tank on there and in two or less seconds it was down to 2000. please help me figure this out. thanks
 

·
Registered
Joined
·
14 Posts
Discussion Starter #12
alright guys or gals. i went and bought a rebuild kit and replaced every o-ring on the bolt, internal and external. the air is still rushing out of the front of the gun. i have a friend that says it might be the noid. do any of you agree?
 

·
Banned
Joined
·
14,001 Posts
its a long shot but it could be, if you have no air in the marker can you hear it clicking when you pull the trigger with eyes off?

check your LPR pressure as well, if it is too low the bolt may be stuck forward and therefore venting, when you air it up and look down the feedneck can you see the bolt sticking forward at all?
 

·
Registered
Joined
·
14 Posts
Discussion Starter #18
alright i dont know if i "reset" my lpr but i took it out and cleaned it and changed all the o-rings and the air is still coming out of the chamber
 

·
Banned
Joined
·
14,001 Posts
no by "reset" he means to return it to its factory setting (measured in turns out from closed tight) basically take out your hex key you use to adjust it, turn it all the way in (clockwise) and then turn it out......umm well i THINK its like 2.5 turns but i could be wrong, i forgot a while ago what stock setting is, anyone know for sure?

its kind of sounding like you took it apart and when you put it back together you just screwed it all the way in which means your noid is not getting any air, if the noid is not getting any air the air in your dump chamber will be pushing the bolt forward slightly untill it clears the top hat and can rush out the barrel

im still looking for an answer on weather or not you see the bolt sticking forward though, it will tell us a lot
 
1 - 20 of 33 Posts
Top