Paintball Guns and Gear forums banner

1 - 3 of 3 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter #1
Hi guys, Hopefully this is an easy answer for someone, I bought this barrel for my MR1, and the shroud and sight are at a 45 degree angle to the gun when the barrel is tightened. I found 2 hex screws but it only loosens part of the shroud, not the sight. Does anyone have any advice for me? Thanks!
 

·
Registered
Joined
·
2 Posts
Discussion Starter #3
Thanks trbo. After fiddling around for a while longer, I finally found out that there are 2 smaller hex screws in the threded holes of the larger 2, those smaller ones hold the discs on the barrel that the shroud attaches to. Not only was i able to adjust the rotation, i was able to move the whole shroud back over the barrel extension so it looks a bit less goofy. Sadly i put a few scratches in the barrel, but nothing some flat black touch up paint wont fix.
 
1 - 3 of 3 Posts
Top