Paintball Guns and Gear forums banner

1 - 1 of 1 Posts

·
Wishes to play Pball moar
Joined
·
493 Posts
Discussion Starter #1
Im not trying to add anything ON it, im trying to take something OFF it. I have a problem; the way the Mach 404 works is that it has a thing inside the hopper vibrates to make the paintballs go into the gun but, i think the shaker is too close to the hole that feeds into the gun, the paintballs can only enter one way so it doesnt feed that well. I want to move the shaker to the top of the hopper so it pushes the paintballs down into the hole when it shakes; how would i do that? :? Heres some pictures of the inside of the hopper:







do you think i can cut off some of it (not cutting the wire of course) and super glue it back together so its shorter? because when you run low on paintballs-when it shakes- the paintballs bounce around the hopper like no tomorrow and no paintballs get fed into the gun. do you think its too risky?
 
1 - 1 of 1 Posts
Top