Paintball Guns and Gear forums banner

1 - 3 of 3 Posts

·
Registered
Joined
·
2,798 Posts
Discussion Starter #1
I recently bought a 32 degrees turbo valve and I installed it but later into my game air was leaking out of my barrel, so tonight I bought a really hard valve spring that the guy recommended at the proshop. When I was taking the upper part of my expansion chamber apart 2 big o-rings flew out and they were a bit damaged, where did these go? Then I installed the new spring and aired it up, all it did was leak heavily. Where do these o-rings go and where can I get them? Also my expansion chamber still feels a bit cold now and it's been about 30 mins, I think some airs still trapped in there, not too sure.
 
1 - 3 of 3 Posts
Top