Paintball Guns and Gear forums banner

1 - 2 of 2 Posts

·
Registered
Joined
·
243 Posts
Discussion Starter #1
well in the need of buying a paintball marker back in like 2000 i bought a viewloader maxis rg (this marker has since become my backup)

well after some extensive marker tinkering trigger spring replacement, polishing all the internals, soon to replace the valve spring and bolt spring with a spring kit)

i am wanting to replace a couple of parts first off the feedneck the factory feedneck is non clamping and to be honest is ugly on the marker

here is a picture i nabbed off pbreiew



what i am looking for is a bolt on feedneck that will work with this marker i would rather not modify the existing feedneck to accept a screw in type clamping feedneck.

the next thing is whats the distance between the holes (center to center) on a spyder rocking trigger and the distance between the rear hole and the selenoid/sear
 

·
i 1!3k 4u70co<K3r5
Joined
·
40 Posts
Spyder 2-hole feednecks should work, and the rocking frame should fit. If the sear is too tall, than shim it down a bit.
 
1 - 2 of 2 Posts
Top