Paintball Guns and Gear forums banner

1 - 20 of 26 Posts

·
Retired, proud dad
Joined
·
702 Posts
-Cock the marker before airing it up.
-Could be the tank o-ring.
-On/off o-ring could be pinched.
-On/off is not in on position. Be careful : do not force the on/off knob, this is the way to pinched the o-ring.
 

·
Retired, proud dad
Joined
·
702 Posts
Did you try to change the tank o-ring even if it looks good ? If not, try that, and put a drop of oil on it to protect it.

http://www.spyder.tv/section/support/manuals/vs2.pdf

check the regulator shematic. I'm speaking about the o-ring org012, org013 and org018 : they can be your problem.
 

·
Administrator
Joined
·
14,016 Posts
try screwing it in more once it starts venting out that port, its a purge hole, its there to help you unscrew the tank, but sometimes the valve pin on the tank opens up before the o-ring is past that hole so it starts spraying out and you just need to screw it in a little more

change the tank o ring as well, between those two you should have it solved, if not just pick up a on/off asa (may want to get one of these reguardless they are very handy)

edit: sorry thats a vs2, i forgot the reg is integraded into the asa, you could get a forgrip reg and a on/off asa but thats a decent amout of money
 

·
Paintball?
Joined
·
7,646 Posts
Yes

If it's out too far, it will leak air
Take your tank off, screw the nut in a bit, screw your tank back on, and reset your pressure
 

·
Paintball?
Joined
·
7,646 Posts
If it's really bothering you, then you could just get a new ASA

You already have a reg besides the ASA reg, so having two is a bit excessive
 
1 - 20 of 26 Posts
Top