Paintball Guns and Gear forums banner

1 - 3 of 3 Posts

·
Registered
Joined
·
48 Posts
Discussion Starter #1
ok ive just got my etek 2 out of my kit bag, turned it on and all it does is flash red/green/blue.

i press the on button again and all 3 lights flash those colours, i cant do any thing else....

help please
 

·
Registered
Joined
·
89 Posts
firs, dont hold down on the trigger when you turn it on, second when you turn it on it gives you a light show. also while it's on the top button flashes to indicate if the eyes r o off or if there is a ball detected in the breach. the o flashes to show your battery strength. if this didnt work, tell me
 

·
Registered
Joined
·
48 Posts
Discussion Starter #3
nope its not that, i got a reply from eclipse here in UK

ill post it for future reference incase anyone else has this problem....

Okey-dokey; here's what's happenned:

You have inadvertently put your marker into the "test" mode that we use here at Eclipse to check that the circuit board is fully functioning. To get out of test mode follow these steps:

- Disconnect the battery pack.
- Ensure that your micro-switch is plugged into your circuit board.
- Connect the battery pack
- Turn the board on and it will start going through the light sequence.
- Pull the trigger EXACTLY five times before the bottom LED finishes its cycle and then wait.
- If you have done it correctly the LEDs will flash white quickly and you'll be back to normal.

Nicky T
 
1 - 3 of 3 Posts
Top