Paintball Guns and Gear forums banner

1 - 4 of 4 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter #1 (Edited)
I can't figure it out. Are the gears stripped? My cyclone feed spins fine with compressed air is attached, but won't spin with CO2. Both tanks were filled to capacity. It will cycle manually, but I can't get a CO2 tank to make it spin like it should with air.
 

·
Administrator
Joined
·
14,016 Posts
it may just be that the pressure difference is effecting your marker kind of stangly, it probably just needs a little adjusting of the cyclone when you switch over to CO2, try giving it a little more pressure when you switch over and see if that does the trick
 

·
Registered
Joined
·
3,032 Posts
HPA normally has a lower pressure than CO2 so if anything it should cycle fine with CO2 but not HPA. All signs here point to a problem with the CO2 tank. I bet it has a small leak or wasn't filled properly you'd be surprised how many people can't properly fill a CO2 tank even though they do it all day long.
 
1 - 4 of 4 Posts
Top